重复频率3Hz、100mJ高光束质量钕玻璃放大器的研制
DOI:
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TN248.1

基金项目:

国家“863”计划重点(2009AA034701)资助项目


Fabrication of repetition frequency 3 Hz,100 mJ high-beam-quality Nd-glass amplifier
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    研制了具有放大纳秒方形激光脉冲的高光束质量、高稳定的激光二极管(LD)抽运的钕玻璃激光放大器。为了获得较高的输出能量,采用LD泵浦的"串联式双程放大"高增益组件进行能量放大。为了获得高光束质量的光斑,利用液晶空间光调制器(LCSLM)对光束近场分布进行空间整形,使之产生特定的空间分布,进而对后级放大器增益不均匀性进行光学预补偿。放大器工作波长为1 053nm,工作频率为3 Hz,输入1nJ的3ns方形激光脉冲,输出激光脉冲能量为100mJ、光束口径为10mm×10mm的方光斑,能量不稳定度小于2%(均方根),净增益大于109。光束的近场调制度小于1.3∶1,远场焦斑衍射极限小于2DL,远场角漂移小于9.5μrad。

    Abstract:

    A high-beam-quality and high-stability all-solid-state Nd:glass amplifier with laser diode(LD) side-pumping applied to amplify a nanosecond laser pulse source has been developed in this paper.The maximum output energy can be obtained when high-gain components with serial two-pass LD pumping amplification are used.On the other hard,the liquid crystal spatial light modulator(LCSLM) is used to produce a particular spatial distribution in the near field to pre-compensate the gain uniformity of the latter amplifier in order to get high-quality spot.The operating wavelength and frequency are 1 053 nm and 3 Hz,respectively.When the amplifier is seeded with a 1 nJ and 3 ns flattened pulse,the output energy is 100 mJ with beam spot of 10 mm×10 mm,energy instability less than 2%(root-mean-square),net gain more than 109.The modulation in the near field is less than 1.3∶1,the diffraction limit of focus spot in the far field is less than 2DL,and the far field angle shift is less than 9.5 μrad.

    参考文献
    相似文献
    引证文献
引用本文

唐熊忻,樊仲维,邱基斯,连富强,张晓雷,赵天卓,麻云凤,苏欣.重复频率3Hz、100mJ高光束质量钕玻璃放大器的研制[J].光电子激光,2012,(4):620~625

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期:
  • 出版日期:
文章二维码