激光快速凝固法制备BaTi4O9微波介质陶瓷
DOI:
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TQ174.6

基金项目:

国家自然科学基金(51072238);河南省教育厅自然科学研究计划(2001B140022)资助项目


Microwave dielectric ceramic BaTi4O9 synthesized by laser rapid solidification
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用激光快速凝固(LRS)法,制备四钛酸钡(BT4,BaTi4O9)微波介质陶瓷,使用X射线衍射仪(XRD)、扫描电子显微镜(SEM)分析晶相构成及显微组织,使用精密阻抗分析仪测试介电性能。结果表明,LRS制备BT4呈层片状结构,具有较高的致密度(相对密度99.6%),其晶粒沿c轴方向(平行于激光入射方向)择优生长,c轴方向择优取向度为0.46。在1 MHz下,介电常数为85,介电损耗为0.083,介电常数温度系数为1.96×10-4。由于在LRS过程中熔体产生极大的温度梯度,因而形成织构化的BT4,介电常数显著提高。

    Abstract:

    Microwave dielectric ceramic BaTi4O9 was synthesized by laser rapid solidifcation(LRS) with CO2 laser.As-synthesized BaTi4O9 has a higher density(relative density is 99.6%.The analysis of X-ray diffraction(XRD) reveals that the samples are of highly pure phase and the grains grow along the c-axis direction with a high lotgering factor of 0.46.The observation of scanning electron microscopy(SEM) shows that the so-synthesized ceramics are composed of plate-like microstructures parallel to the laser incident direction.The dielectric constant,dielectric loss and temperature coefficient of dielectric constant are 85,0.083 and 1.96×10-4 at 1 MHz,respectively.The strong temperature gradient in the sample′s interior generated during the solidification process results in the appearance of textured microstructure and the improvement of dielectric constant.

    参考文献
    相似文献
    引证文献
引用本文

张俊吉,李明玉,李德川,晁明举,梁二军.激光快速凝固法制备BaTi4O9微波介质陶瓷[J].光电子激光,2012,(4):703~707

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期:
  • 出版日期:
文章二维码